Community

2 Axis transiton at the ends

Posted by Hennag Hansen on February 10, 2017 at 7:09am

Hi there

I was wondering if it is possible to adjust the transition speed at the ends of the winding. As the ends tend to slip I am thinking a slower Transition from 45 to 90 degrees at the ends may improve this problem.

Any thoughts on that?

You need to be a member of X-Winder to add comments!

Join X-Winder

Email me when people reply –
Follow

Replies

  • Miloš Marec February 10, 2017 at 7:30am

    I use "Add extra 360deg. to every pass" in XWinder settings...No problem.

    For angles 33° I think about pin rings...

    Miloš

    • Hennag Hansen > Miloš Marec February 14, 2017 at 2:27am

      I've tried some 3M Duallock Velcro as a pin ring.

      I am using the 4 axis model in 3 axis mode and there there is no option for extra 360 deg in every pass.

This reply was deleted.