No Movement from the X-Winder Motors

We are having trouble getting any sort of response from the motors in the 4-Axis Model 4X-23 Winder, such as the ones that move the mandrel and the carriage. When connecting our computer to the USB hub that houses the connections to the control boards, we get the green light showing that we do have a positive connection to the hardware, however the motors do not begin to idle and do not receive any commands in the executor. We have correctly matched the Board ID#'s from previous uses of the X-winder, but still receive no movement from the motors. The motors were repaired over the summer because performance was lacking, but we have not had the opportunity to break down the motors and inspect. 

Wondering if anyone else has encountered this problem, and looking for any advice. Thanks!

You need to be a member of X-Winder to add comments!

Join X-Winder

Email me when people reply –

Replies

  • Hello Oskar,

    we've had a similar problem during setup, our mandrel and carriage motor only started buzzing but received no movement. We finally ended up in removing the endplate of the motors to get them running. More details in my previous post:

    http://community.xwinder.com/forum/nema23-motors-not-working

     

    Hope that helps ;)

    NEMA23 Motors not working
    We recently bought the 4X-23 model and now have the problem that the 2 NEMA23 for carriage and mandrel cannot be controlled. DH works perfectly fine.…
This reply was deleted.