Hello All!
I have a custom machine, 105 IN carriage.
Mandrel is 6:1
Carriage uses T2,5 mm teeth 1º pulley 20 to 2º pulley 60 teeth.
My problem is that 4.2 seems not posible to configure carriage out of standard gearing…
Read more…is there a calualtion or table where is can figure out the thickenss of different degree completed layers. like i have incountered that 12k tow at 75 degrees is .48-.55 mm for a completed single layer. this would be really helpful when trying to…
Read more…Has anyone made a heated batch so the resin could be warmed to ~40-50C?
Read more…if I'm wrapping a oval shaped mandrel thats about 80mm by 30mm what do i set at the mandrel size in the software? 80mm? or do i have to calculate the circumference?
Read more…when i begin my winding (2x) the carriage will go to the limit switch and then begin the next process but when it comes back it will hit the limit switch hard and just bang against it. i have tried messing with the z offset value but it keeps…
Read more…Hi,
Has anyone else encountered an error with the delivery head were at a random point in a wind sequence it will just ram the payout eye into the mandrel and drag it along to the end of carriage axis? I have checked the g-code and cant…
Read more…Hello.
Explain what the parameter A means in each frame of the G code please.
G1 F4,00 Z21,35 S10,25 C112,81…
Read more…I also made this roller with teflon stock. It's kept in place with two aluminum angles with pins as axle so it rolls…
Read more…I made this roller gluing two concave rollers and washers. This helps keeping the filament centered. I was having issues…
Read more…Hi there
I was wondering if it is possible to adjust the transition speed at the ends of the winding. As the ends tend to slip I am thinking a slower Transition from 45 to 90 degrees at the ends may improve this problem.
Any thoughts…
Read more…Hi
Trying to get my 4 axis to do a test part and I keep getting various too slow errors at the ends. I've tried slowing things down, splitting the USB hubs so they aren't daisy chained and a different PC. Nothing seems to…
Read more…