Hi everyone,
awhile back ago I posted about how I was gettiing gaps. I thought winding slow would minimize those gaps, but I still end up with lots of huge gaps. Most of them seem to occure on the L602 returns. As for the L601 returns they all land perfectly where they are supposed to be. Attached is a photo of a 3 inch fiberglass and kevlar combination. Note the kevlar wind on the L601 returns are perfect while the L602 returns have huge gaps in them.
Has anyone figured out what could be the causing this? I am currently using version 4.17 as version 4.20 would cause a glitch where the carriage would slam into the limit switch. Even though my Z-offsets were correct it would still slam into the limit switch.
Comments