is there a calualtion or table where is can figure out the thickenss of different degree completed layers. like i have incountered that 12k tow at 75 degrees is .48-.55 mm for a completed single layer. this would be really helpful when trying to decide layup when shooting for a specific thikness final product.
You need to be a member of X-Winder to add comments!
Replies
I have been getting 0.005 inches or 0.127mm with 12K tow. Do you shrink wrap your tubing? The only one that gives me 0.45mm or 0.018 inches is a 24K tow. No matter which angle I use this is what I get.