Community

Resolution of the Carriage Issues

Hey everyone, 

I'm new to the X winder work and I was just wondering how fine the motion of the carriage can be? I'm trying to move in very small increments to the righ, but I'm stuck at intervals of 0.010 (in the z axis). Has anyone run into this problem? If so, how did you fix it? Did you adjust the steps that the stepper motor takes so that the intervals were smaller? If so, how did you access that script? Thanks in advance! 

You need to be a member of X-Winder to add comments!

Join X-Winder

Email me when people reply –