Hennag Hansen replied to Hennag Hansen's discussion 2 Axis transiton at the ends
"I've tried some 3M Duallock Velcro as a pin ring.
I am using the 4 axis model in 3 axis mode and there there is no option for extra 360 deg in every pass."
Feb 14, 2017
Hennag Hansen posted a discussion
Hi thereI was wondering if it is possible to adjust the transition speed at the ends of the winding. As the ends tend to slip I am thinking a slower Transition from 45 to 90 degrees at the ends may improve this problem.Any thoughts on that?
Feb 10, 2017
Hennag Hansen replied to Antonin Herbeck's discussion Pins at the ends of mandrel
"I am thinking about using Velcro at the ends."
Feb 10, 2017
Hennag Hansen replied to Hennag Hansen's discussion Issues with 4th axis
"Ok figured a few things out now
The reason for most of my problems is the DHR Stepper losing steps. Mainly due to high friction. After a lot of fiddling and sanding I was able to reduce the friction quite a bit. 
Took a while until I found out that…"
Dec 15, 2016
Hennag Hansen replied to Hennag Hansen's discussion Issues with 4th axis
"Thats what i have done now and looks ok
but there is still the misalignment issue when the carriage is on the left side. haven't tried setting up my winding schedule in inch "
Dec 14, 2016
Hennag Hansen posted a discussion
Hi therei just assambled the Xwinder and startet runnig some tests.Now there are some issues with die DHR axis. Firstly on the drawings tabbed ring for locating the axis seems to be at a 45° angl towards the roller which isn't possible if the holes…
Dec 13, 2016
Hennag Hansen is now a member of X-Winder
Dec 13, 2016