Lauri Valtonen replied to Hennag Hansen's discussion Issues with 4th axis
"Make sure that you have 1,8 amps going to the motor."
Dec 15, 2016
Lauri Valtonen replied to Hennag Hansen's discussion Issues with 4th axis
"Hello
I guess you could try if your delivery head is really 0 deg when the software thinks that it is in 0 deg.You can test it out by manually driving the rotaryhead to limit switch then to 0 deg. It should be horizontal at 0 deg

and also i think t…"
Dec 14, 2016
Lauri Valtonen and Jarkko Kononen are now friends
Jul 18, 2016
Lauri Valtonen replied to Nicholas Finch's discussion Finishing Tips and tube thickness
"Hello Henry,
I've studied the G-code quite a lot now and I guess that the first thing to do is to check that your mandrell is rotating properly. I had issues with the ratio because (in my case at least) the system messes up the ratio if I run it man…"
May 20, 2016
Lauri Valtonen posted a discussion
Hello everyone.I have worked with this winder for few weeks now. I'm still unable to get DH Linear to work properly. The problem seems to be that the executor software doesn't recognize the position signal from the motor. If i check "Help"-> "about"…
May 20, 2016
Lauri Valtonen is now a member of X-Winder
May 17, 2016