Hello,We are running through getting our university's XWinder repaired and recalibrated and have run into a snag with the DH Rotary not being horizontal after zeroing. When we home the machine, the Rotary axis rotates until the limit switch is hit, then rotates back to its zero position, but this zero position is about 15 degrees off horizontal which is giving a +-15 degree rotational offset to our test winds.We have been unable to find anything about how to configure this in either the installation instructions or software, and we cannot use the machine until this is resolved.Any help would be appreciated, thank you.
are you still having this problem ?
Can you send a short 0:10s video ?
send to firstname.lastname@example.org