When I try changing my Z-axis offset to a different number, the winder does not go to that location. My z- axis offset was set to 2.5 inches, I wanted to change that to 5 inches, and even though on I saved the z axis offset as 5 inches, the winder continues to go to the 2.5 inch location instead of the 5 inch location.
Is there anything I should do or am doing incorrectly? I am currently using the 14.9 version of software.
Comments
The Z-Axis offset is the Z measurement when the carriage is in the home position (ie, when the carriage activates the carriage limit switch). See this explanation:
https://www.dropbox.com/scl/fi/0l6bvrv7zb6e9m7v2676z/Z-Axis_Explain...