"The Z-Axis offset is the Z measurement when the carriage is in the home position (ie, when the carriage activates the carriage limit switch). See this explanation:
https://www.dropbox.com/scl/fi/0l6bvrv7zb6e9m7v2676z/Z-Axis_Explain..."
https://www.dropbox.com/scl/fi/0l6bvrv7zb6e9m7v2676z/Z-Axis_Explain..."
When I try changing my Z-axis offset to a different number, the winder does not go to that location. My z- axis offset was set to 2.5 inches, I wanted to change that to 5 inches, and even though on I saved the z axis offset as 5 inches, the winder…
"Pre-Wrap allows you to wrap a covering of your choosing (packing tape, masking tape, etc) over your mandrel prior to actually winding filament on the mandrel. The pre-wrap material would help the final part be pulled from the mandrel more easily…"
Hi, I was wondering what pre wrap does, is it helpful in the winding process? My team is thinking of winding without it and was wondering what the implications of that would be. Thanks!
"Please see attached explanation and make sure you are running version 4.19 of the X-Winder Software"
When I run the program, the X-Winder will stop once it hits the carriage limit switch, and then it will keep going past the limit switch. This keeps happening, and I had to buy more limit switches as this has broken the prior limit switch. At first…
