Z Axis offset does not updating location

When I try changing my Z-axis offset to a different number, the winder does not go to that location. My z- axis offset was set to 2.5 inches, I wanted to change that to 5 inches, and even though on I saved the z axis offset as 5 inches, the winder continues to go to the 2.5 inch location instead of the 5 inch location.

Is there anything I should do or am doing incorrectly? I am currently using the 14.9 version of software. 

E-mail me when people leave their comments –

You need to be a member of X-Winder to add comments!

Join X-Winder


This reply was deleted.