Community

Executor stuck at G2 command

Posted by Ken Hendrawan on March 16, 2023 at 12:43pm

Hello,

I'm doing a single layer wind and I've noticed that the Executor gets stuck at the first G2 CW ellipse at left end. Only the mandrel keeps rotating but all other movements stop. The last total mandrel rotation is 366 degrees but it far surpasses that. Are there any others with this issue? My total run time is supposed to be ~10 minutes and I've seen that it is stuck on this line for more than 80% of the total run time.

 

Thanks.

E-mail me when people leave their comments –
Follow

You need to be a member of X-Winder to add comments!

Join X-Winder

Comments

  • Megan Clements April 28, 2023 at 4:00pm

    I am having the same issue, except with v4.22 but the exact line it gets stuck at changes each time. At our most recent wind, the X-Winder executer was showing a phi of 1500 before we stopped the wind

  • Turner Hunt March 16, 2023 at 1:07pm

    Are you running v4.25 or v4.18 of the X-Winder software ? Go to menu item Help, then about

    • Ken Hendrawan > Turner Hunt March 16, 2023 at 7:39pm

      I have the 4.18 software.

       

    • Hande Hanedan > Ken Hendrawan April 7, 2023 at 7:04am

      I have the same problem with v4.18 software. 

This reply was deleted.