Gender
Female
"Hi! did you end up having any luck on that front? We're doing the same project for a capstone and experience significant errors when we try to wind on a non constant diameter (unpredicatble behavior each wind, sometimes stopping completly,…"
"I am having the same issue, except with v4.22 but the exact line it gets stuck at changes each time. At our most recent wind, the X-Winder executer was showing a phi of 1500 before we stopped the wind"
"After installing the software onto someone else's computer and inputting the exact same measurements the problem went away. Not sure if anyone has had any similar problems with the software."
We're attempting to do a 4 axis wind with this setupBased on my understanding of the software, the winding path should be from 3.75 inches from the inside of the post to 15 inches. Instead the winder is moving from approximately 10 inches to 21…
Comments
Good Day,
How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself here, since it's a public site.Could you please get back to me on:(mrsstellaabudheir@gmail.com ) for the full details.
Have a nice day
Thanks God bless.
Stella.