Ken Hendrawan commented on Ken Hendrawan's blog post Executor stuck at G2 command
"I have the 4.18 software.
 "
Mar 16
Ken Hendrawan posted a blog post
Hello,I'm doing a single layer wind and I've noticed that the Executor gets stuck at the first G2 CW ellipse at left end. Only the mandrel keeps rotating but all other movements stop. The last total mandrel rotation is 366 degrees but it far…
Mar 16
Ken Hendrawan commented on Ken Hendrawan's blog post CADWIND->Xwinder
"I was going to basically just copy and paste the g-code CADWIND exports and paste it into the X-winder however I tried that and it still gave the same result. I'll just go ahead and use the Designer software, thank you!
 "
Mar 14
Ken Hendrawan commented on Ken Hendrawan's blog post 4X-23 tutorials
"Right, but is there a tutorial on how to actually wrap the fiber around the rollers/posts for tensioning? Thanks."
Mar 14
Turner Hunt commented on Ken Hendrawan's blog post CADWIND->Xwinder
"I'm not sure what you mean Ken, but X-Winder only understands X-Winder G-Code or modifications thereto."
Mar 13
Ken Hendrawan commented on Ken Hendrawan's blog post CADWIND->Xwinder
"Thanks for letting me know. So then if I wanted to run the g-code CADWIND exports, I'd essentially have to rewrite it in the Xwinder Designer software?
 "
Mar 13
Turner Hunt commented on Ken Hendrawan's blog post 4X-23 tutorials
"There is a "tailoring" process that is described in that video to optimize the DH movement so that does not happen. "
Mar 13
Turner Hunt commented on Ken Hendrawan's blog post CADWIND->Xwinder
"CADWIND will not work with X-Winder. X-Winder uses its own software that is sold with the X-Winder filament winder. Likewise, Other winders will not work with the X-Winder software. If you are trying to create special capabilities with the X-Winder,…"
Mar 13
Ken Hendrawan posted a blog post
Hi all,Has anyone interfaced the winding software CADWIND successfully to the Xwinder? I'm having issues where the g-code that CADWIND exports causes very staggered machine movements and often times is very short. Any help would be…
Mar 13
Ken Hendrawan commented on Ken Hendrawan's blog post 4X-23 tutorials
"Thanks for the reference, I'll go watch this. Is there a section on how to mount the fibers on the winder? I'm trying to go based off of intuition but my fibers keep slipping off/untensioning when the winds start."
Mar 13
Turner Hunt commented on Ken Hendrawan's blog post 4X-23 tutorials
"have you seen the x-winder YouTube Channel, lots of stuff there:
particularly this video on the 4X-23:
https://youtu.be/MxvUU7Ig1yI
and the channel here:
http://www.youtube.com/channel/UC7HfbikSL9N86xxmdMmXZPA"
Mar 7
Ken Hendrawan posted a blog post
Hi all,I hope this is the right place to ask but I'm new to filament winding and recently set up a 4X-23 unit. I wanted to know if there's a guide on how to set up the winder, going from calibration, fiber loading, to g-code execution and how the…
Mar 7
Ken Hendrawan commented on Nicholas D. Crowder's blog post DETACHED: PhidgetStepper Phidget Bipolar Stepper Controller
"Nicholas D. Crowder Turner Hunt Adding onto this thread after a while, any resolves? I encountered the same issue. Thanks."
Mar 2
Ken Hendrawan is now a member of X-Winder
Mar 2