"Hi.
No, I didn't get any answer from X winder directly. I know from the distributor in Switzerland, that there is a new software release which should clear the problem. But, the new software release just remove the calibration of the z axis and…"
No, I didn't get any answer from X winder directly. I know from the distributor in Switzerland, that there is a new software release which should clear the problem. But, the new software release just remove the calibration of the z axis and…"
"Hi,
Did you ever get an answer to your question?
I have the same question.
vernon"
Did you ever get an answer to your question?
I have the same question.
vernon"
Hi all.We have a 4X-23 X-Winder. At step 4 of the Setup wizard, we have the issue that the carriage don't move towards the limit switch after pressing the button "Go to the limit switch". Without this calibration the values of the z axis aren't…
Comments
Good Day,
How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself here, since it's a public site.Could you please get back to me on:(mrsstellaabudheir@gmail.com ) for the full details.
Have a nice day
Thanks God bless.
Stella.