Vernon Hultzer replied to Alastair Barnett's discussion Rotate Mandrel in CCW direction
""
Mar 13
Vernon Hultzer replied to Alastair Barnett's discussion Rotate Mandrel in CCW direction
"Alastair,
its very easy to reverse the polarity. See the attached image.
vernon"
Mar 13
Vernon Hultzer replied to Alastair Barnett's discussion Rotate Mandrel in CCW direction
"Alastair,
 
From what I understand, the M4 command is a non continuous rotation command, so this means that you have to put an angle of rotation.  You could try a big rotation angle, like C=3,600,000, which is 360x10,000 (10,000 rotations), then use…"
Mar 13
Vernon Hultzer replied to Alastair Barnett's discussion Rotate Mandrel in CCW direction
"Alastair,
I'm using software version 4.22
 
Vernon"
Mar 13
Vernon Hultzer replied to Alastair Barnett's discussion Rotate Mandrel in CCW direction
"Hi,
 
im using code, which rotates the mandrel CW and CCW:
 
M4 S20 C180 [clockwise rotation 180deg]
M4 S20 C-180 [counterclockwise rotation 180 deg]"
Mar 12
Vernon Hultzer replied to Ross Knutson's discussion Stepper seizing with one axis controller
"Yes, excellent customer service."
Feb 27
Vernon Hultzer replied to Ross Knutson's discussion Stepper seizing with one axis controller
"Hi,
 
I have the same issue on a brand new 4-23.  It was a bad axis controller.  Having to replace it.
 
Vh"
Feb 26
Vernon Hultzer replied to Carolin Sitzmann's discussion Carriage calibration 4X-23
"Hi,
Did you ever get an answer to your question?
I have the same question.
 
vernon"
Feb 25
Vernon Hultzer is now a member of X-Winder
Feb 20