Gender
Female
"See attached - please revise your dimensions. You need to give more time for the DH to withdraw itself from its most forward position (this is the source of the "too slow" error). Also, on the "detached" USB problem, replace your un-powered USB hub…"
"We were able to do a dry run fine on these dimensions. I am not sure what would make the change. I will try the RPM and let you know what happens. Thanks! "
"Pleae respond to this with a screen shot of the Designer software showing the dimensioned measurements of the mandrel. Its possible that the fore/aft distance of the DH is very short or very long causing ther "too slow" error message - its also…"
Hey,I am using the 4.16 version. As the carrier reaches the left and right ends of the mandrel, the DH does not advance to the left or right DH advance point. It stays at the DH Offset from mandrel surface. After the [CW ELLIPSE AT LEFT END] move, I…
Comments
Good Day,
How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself here, since it's a public site.Could you please get back to me on:(mrsstellaabudheir@gmail.com ) for the full details.
Have a nice day
Thanks God bless.
Stella.