Gender
Male
"I agree with you Alexander, it must be an error in the g-code execution. I have the same issue with my 4x-34 (in 3-axis mode) and 4.17 version (my dh linear control board is not recognized by the 4.20 software... but that's an another problem). The…"
I'm winding filament (1mm diameter) with my 4 axis x-winder. On the software, i'm using 4 mm thickness to create spacing between filaments on the mandrel. However, when the machine goes home to far end, the spacing is not consistent and there…
Comments
Good Day,
How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself here, since it's a public site.Could you please get back to me on:(mrsstellaabudheir@gmail.com ) for the full details.
Have a nice day
Thanks God bless.
Stella.
I'm using a Laptop (hp)
William Roy, what type of computer are you using to wind? (Example: laptop, surface pro, or PC)