Gender
Male
- Activity Feed
- Photos
- Blog Posts
- Discussions
- Comment Wall
- About
Loading ...
"Aaron,
Did you have any luck with designing an automated tensionor system yet? I need one! I had a few ideas myself, but after reading how winding angle changes tension, my ideas may be a moot point.. Any insight would be greatly appreciated! …"
Did you have any luck with designing an automated tensionor system yet? I need one! I had a few ideas myself, but after reading how winding angle changes tension, my ideas may be a moot point.. Any insight would be greatly appreciated! …"
"Did you find a fresh link? im havingthe same problem.
"
"
"What temp are we talking about? Most high temp epoxy require a post cure at elevated temp like in a oven. I find good deals on carbon tow on ebay. Also check out a company called Fiber- Line for filiment needs. Epoxies are everywhere, Pro-Set, ebay,…"
"No problem Gary,
The tension setting will change on the winding angle. Even as the diameter increases the tension can change on the same winding angle because you essentially have more friction to hold your windings in place.
You want to aim for a…"
The tension setting will change on the winding angle. Even as the diameter increases the tension can change on the same winding angle because you essentially have more friction to hold your windings in place.
You want to aim for a…"
"Thank you Aaron! This information is very helpful. Im certain i need some more work on my roller/filiment delivery drag. im thinking of using a fish scale to test the tension on the filiment. Do you have any suggestions on the amount of tension in…"
"Hi Gary,
I will try to answer all of your questions.
More or less torque on the mandrel motor is not really going to help you. The stock standard nema23 motor has plenty enough torque to wind a good tube. All the other motors require very little…"
I will try to answer all of your questions.
More or less torque on the mandrel motor is not really going to help you. The stock standard nema23 motor has plenty enough torque to wind a good tube. All the other motors require very little…"
I am new to the x winder. After a few hickups, I completed some good 2 axis winds in 3 axis mode. My question is on the subject of winding torque... How do i know if i need more torque or less torque on a particular motor? Do i increase torque for…
Loading ...
You need to be a member of X-Winder to add comments!
Location
Brownsburg, IN
Comments
Good Day,
How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself here, since it's a public site.Could you please get back to me on:(mrsstellaabudheir@gmail.com ) for the full details.
Have a nice day
Thanks God bless.
Stella.