"We once made measurements for fibre tension and reached a maximum of 12N (~2.6lbs). However, in our setup, we could have tightened the velcro strap a little more and additionally the strap was placed on the plastic spool holder. So, I assume you…"
Hello all,after many trials, we still have problems with fibre slippage on left end but right end works perfectly.For various winds the fibre aligns excentrical on the DH roller during the linear pass to left end. An additional tool before the…
"We had various issues before changing the energy settings of the PC and as mentioned it turned out that it neither was software related nor hardware related.
We turned off all energy saving options and particularly the energy saving options for the…"
"If I understood your problem correctly, we could have had similar issues with our X-Winder. We also tried various PCs, both laptops and desktop PCs. We finally found the most probable root cause in the energy saving settings of the PCs.
So we turned…"
"Hello Oskar,
we've had a similar problem during setup, our mandrel and carriage motor only started buzzing but received no movement. We finally ended up in removing the endplate of the motors to get them running. More details in my previous post:…"
"Hello all,
we played around a little and tried quite everything to get the motors running. The more we tried the more it seemed to be a hardware issue so finally we ended up partially dissasembling the motors. After simply removing the endplate of…"
We recently bought the 4X-23 model and now have the problem that the 2 NEMA23 for carriage and mandrel cannot be controlled. DH works perfectly fine. All axis controllers have been tested for all motors but problem remained. Hence, X-Winder setup is…