Gender
Male
- Activity Feed
- Photos
- Blog Posts
- Discussions
- Comment Wall
- About
Loading ...
"Good morning Ross,
test runs were done with 2400tex dry glass fibres. Up to now, couple of modifications were implemented to more or less successfully wind thermoplastic prepreg UD-Tape. Of course, we also had issues with the filament sliding off…"
test runs were done with 2400tex dry glass fibres. Up to now, couple of modifications were implemented to more or less successfully wind thermoplastic prepreg UD-Tape. Of course, we also had issues with the filament sliding off…"
"Hi were having the same issue but at both ends. Can I ask please what weight fillament are you using and do you have any issues of the fillament sliding off the sides of the delivery head roller?
Regards Ross Australaia "
Regards Ross Australaia "
"We once made measurements for fibre tension and reached a maximum of 12N (~2.6lbs). However, in our setup, we could have tightened the velcro strap a little more and additionally the strap was placed on the plastic spool holder. So, I assume you…"
Hello all,after many trials, we still have problems with fibre slippage on left end but right end works perfectly.For various winds the fibre aligns excentrical on the DH roller during the linear pass to left end. An additional tool before the…
"We had various issues before changing the energy settings of the PC and as mentioned it turned out that it neither was software related nor hardware related.
We turned off all energy saving options and particularly the energy saving options for the…"
We turned off all energy saving options and particularly the energy saving options for the…"
"If I understood your problem correctly, we could have had similar issues with our X-Winder. We also tried various PCs, both laptops and desktop PCs. We finally found the most probable root cause in the energy saving settings of the PCs.
So we turned…"
So we turned…"
"Hello Oskar,
we've had a similar problem during setup, our mandrel and carriage motor only started buzzing but received no movement. We finally ended up in removing the endplate of the motors to get them running. More details in my previous post:…"
we've had a similar problem during setup, our mandrel and carriage motor only started buzzing but received no movement. We finally ended up in removing the endplate of the motors to get them running. More details in my previous post:…"
"Hello all,
we played around a little and tried quite everything to get the motors running. The more we tried the more it seemed to be a hardware issue so finally we ended up partially dissasembling the motors. After simply removing the endplate of…"
we played around a little and tried quite everything to get the motors running. The more we tried the more it seemed to be a hardware issue so finally we ended up partially dissasembling the motors. After simply removing the endplate of…"
We recently bought the 4X-23 model and now have the problem that the 2 NEMA23 for carriage and mandrel cannot be controlled. DH works perfectly fine. All axis controllers have been tested for all motors but problem remained. Hence, X-Winder setup is…
Loading ...
You need to be a member of X-Winder to add comments!
Comments
Good Day,
How is everything with you, I picked interest on you after going through your short profile and deemed it necessary to write you immediately. I have something very vital to disclose to you, but I found it difficult to express myself here, since it's a public site.Could you please get back to me on:(mrsstellaabudheir@gmail.com ) for the full details.
Have a nice day
Thanks God bless.
Stella.