Community

All Discussions (39)

Sort by

Carriage Direction?

I've set up and have been getting familiar with the setup (we have a 4X-34 setup).  Everything seems to running smooth, except the carriage directionality seems to be off.  When I press the 'right' option the carriage goes away from the end with…

Read more…
1 Reply · Reply by Aaron Lederhose 3 hours ago

Filament Skipping

Hi everyone this is my first time posting here. I am noticing an issue with the start of the second pass of a helical wind. On the second pass it tends to space out a good distance from the first pass going from right to left. On the return from…

Read more…
0 Replies

Variable Winding Angle? Cone Formation

Hi, I am comtemplating purchasing an x-winder to do some prototyping and I wanted to make sure the system will meet our needs.  In the x-winder software, are you able to vary the wind angle within a single layer? We are wanting to produce a cone…

Read more…
1 Reply · Reply by Scott Oct 8

layer thickness

is there a calualtion or table where is can figure out the thickenss of different degree completed layers. like i have incountered that 12k tow at 75 degrees is .48-.55 mm for a completed single layer. this would be really helpful when trying to…

Read more…
1 Reply · Reply by Alexander Solis May 12